| Version | 1.2.0 |
|---|---|
| Supported Products | EOS R1, EOS R5 Mark II, EOS R5, EOS R6 Mark III, EOS R6 Mark II, EOS R5 C, EOS C80 |
| Supported NLEs | Apple Final Cut Pro 10.6.6 or later |
| Supported Recorder |
Supported Products
EOS R1, EOS R5 Mark II, EOS R5, EOS R6 Mark II, EOS R5 C, EOS C80 Supported Recorder／Firmware Ver. ATOMOS Ninja Ultra, Ninja, Ninja V, Ninja V+, Shogun Ultra, Shogun CONNECT, Shogun ※AtomOS 11.13.00 or later is required. Supported Products EOS R1, EOS R5 Mark II, EOS R5, EOS R6 Mark III, EOS R6 Mark II, EOS R5 C, EOS C80 Supported Recorder／Firmware Ver. ATOMOS Ninja TX, Ninja TX GO ※AtomOS 12.2.1 or later is required. |
| System requirements |
Installation Requirements
The following software must be installed on the PC - Final Cut Pro 10.6.6 or later Supported OS Same as the support conditions of Final Cut Pro Hardware Requirements Same as the support conditions of Final Cut Pro RAM Same as the support conditions of Final Cut Pro GPU Required operating environment *The following environment is required to handle clips with a resolution of less than 8K. - Mac with VRAM 2GB or more GPU (including built in) *The following environment is required to handle 8K resolution clips. - Mac with VRAM 4GB o r more GPU (including built in) Recommended System Configuration - iMac Pro equipped with AMD Radeon Pro Vega 64 or - Mac Studio equipped with Apple M1 Ultra chip 64 core GPU Display Same as the support conditions of Final Cut Pro |
| Setup |
Please refer to the instructions below on how to download and install the software.
Exit all other applications when installing this software.
|